Astrid Karstensens shipyard purer/trawler skagen

Karstensens Shipyard has delivered the new purser/trawler ASTRID to owners, the Johansson family of Astrid Fiskeri A/S, Skagen

New build 455 “ASTRID” was handed over to owners Johansson family of Astrid Fiskeri A/S, Skagen on 11 August 2022 from Karstensen Shipyard.

The hull for “ASTRID” was built by Karstensen Shipyard Poland in Gdynia, and arrived in Skagen in November 2021.

New “ASTRID” replaces Johanssons previous command of the same name. In addition to this new vessel, the owners also operates the pelagic trawler “ASTRID-MARIE”, under Swedish flag.

The vessel design, specification and arrangements is a result of an extensive and close cooperation between owners and yard where all solutions are optimized and tailor made to suit owners and crews specific requirements.

Main focus has been set on optimizing working, safety and comfort for the crew, optimizing catch handling- and storage facilities and optimizing of fuel consumption. In order to reach above targets, the vessel is fitted out with all the newest developed machinery and equipment.

Astrid Karstensens shipyard purer/trawler skagen

The new 91.80M metre ASTRID built by Karstensens Shipyard

 DESCRIPTION:

The hull is built in steel with three continuous decks; and with long forecastle- and boat decks. Wheelhouse, boat decks, funnel and masts are built in aluminium.

Hull shape of round bilge construction with bulbous bow and stern skeg, vertical wave-piercer stem and transom stern.

Below main deck the hull is subdivided into the following watertight compartments: Forepeak, bow thruster-/sonar room, insulated RSW-tank section with 13 tanks and central RSW pump- and manifold room, engine room with main engine connected to reduction gearbox with one, ducted propeller and aftpeak with fuel- and lub oil tanks.

In order to create best possible design for low noise, the accommodation is located as far away from the propeller as possible. In addition a number of constructive steps were made, in order to create a low noise level. During trails noise measurements showed levels well below any requirements and recommendations.

Astrid Karstensens shipyard purer/trawler skagen

The Astrid-Marie GG 64 alongside the new ASTRID S 264

ASTRID

MAIN DIMENSIONS

Length overall … 91.80 m

Length between PP … 87.00 m

Breadth moulded … 17.00 m

Breadth at stern … 18.00 m

Depth 1st deck … 12.10 m

Depth 2nd deck … 9.30 m

Depth 3rd deck … 6.80 m

Frame spacing … 600 mm

Tonnage … 4,697 GT

RSW-tanks … 3,225 cum

Fuel oil … 599 cum

Fresh water … 135 cum

Design: Karstensens Skibsværft A/S

Trial speeds / average;

19.3 knots, diesel-mechanical / speed step 1.

17.5 knots, diesel-mechanical / speed step 2.

Hull: – built by Karstensen Shipyard Poland, Gdynia, Poland.

Class: DNV +1A Fishing Vessel E0 TMON, hull: Ice-C.

ASTRID

WHEELHOUSE: ELECTRICAL & ELECTRONICS

ASTRID WHEELHOUSE KARSTENS SHIPYARD

Insiide the wheelhouse on the new ASTRID S 264

ELECTRICAL:

LED navigation lights: Den Haan.

Search light: 2 x Polarlight LED.

Tank level controls: Mobrey alarms.

Electrical contractor: KS Elektro.

Power management: Deif Delomatic 4 PMS system.

Main switchboard: ScanTechnic, Denmark.

Vessel is fitted with frequency converter for floating frequencies between 50 and 60 Hz.

Alarm panel / IAS: Marine Control Services.

ASTRID WHEELHOUSE KARSTENS SHIPYARD

ELECTRONICS

Extensive array of electronic equipment (navigation, fish finding and communication), all supplied by Furuno, Scanmar and Simrad. Simrad equipment is supplied by Sea Mech.

Main items:

Display system: Furuno Smart Bridge

Main monitors; 5 pcs 55” Olorin.

16 pcs 32” Hatteland.

6 pcs 27” Hatteland.

ASTRID WHEELHOUSE KARSTENS SHIPYARD

LF sonar 1: Furuno FSV-25S, 15-25 kHz.

LF sonar 2: Simrad ST94, 25 kHz.

MF sonar: Furuno FSV-85, 80 kHz.

HF sonar: Simrad CS-94.

Echo sounder 1: Simrad ES80

Echo sounder 2: Furuno FCV-38.

Echo sounder 3: Furuno FCV-1900.

Echo sounder 4: Furuno FSS3-BB

3D sonar: WASSP 80 kHz

Current indicator: Furuno CI68.

Net monitor: Marport.

Trawl sonar: Simrad FS-70.

astrid deck aft

Radar 1 (3 cm): Furuno FAR 2228-X.

Radar 2 (10 cm): Furuno FAR 2228-S.

Radar 3: Furuno DRS6A-NXT

Ecdis: Furuno FMD-3200.

Plotter 1+2: MaxSea Time Zero.

Plotter 3: Olex, 3D.

Plotter 4: Sodena.

GPS: Furuno GP-170

AIS: Furuno FA-170

Gyro compass: 2 x Simrad RGC-80.

GPS compass: Furuno SC-130.

Furuno SC-70.

Autopilot: Simrad AP70-system.

VDR: Furuno VR-7000 VDR

ASTRID WHEELHOUSE KARSTENS SHIPYARD

V-sat communication: 2 x Sailor 900

Sat-TV system: Sailor

GMDSS: Furuno equipment for A3 navigation.

VHFs: Furuno.

 

Autotrawl system: Kongsberg.

ME remote control: Wartsila.

Intercom: Vingtor Stentofon,

ASTRID

ENGINE ROOM & MACHINERY

astrid engine room

Design principles for main engine / auxiliary arrangement are as follows:

Vessel is fitted with a 7320 kW main engine, connected to one reduction gearbox, driving one propeller. Shaft alternator of 3300 kW is fitted to gearbox PTO.

To supply additional electric power, the vessel is fitted with 2 auxiliary engines / gen-sets, producing 940 kWe each as well as a harbour gen-set of 500 kW.

During heaving/shooting operations at fishing, when the winch system is in use, the shaft alternators will be engaged, and electric power will be supplied from here. When there is demand for full power on the winch(es), there will normally not be same demand for power on the propulsion system. Following the main engine will be power source for both propulsion and hydraulic system.

All electrical power systems are controlled by the vessels DEIF Power-Management-System. Further on bus-bar breaker is fitted in main switchboard, allowing aft thrusters to be fed off shaft alternator and forward thruster and vessels hotel load off the diesel generator set.

Electrical power system is fitted for sliding frequency (60-50 Hz), by means of frequency converters for 400/440 V and UPS clean power static supply/converter for 230 V. This will allow main engine and propeller rpm to be reduced with 17%.

ENGINES AND MACHINERY

Main engine: Wartsila 12V31, 7320 kW @ 750 rpm.

Propeller plant: Wartsila 4G1190, d4800 mm.

Reduction gearbox: Wartsila SCV 112/2-PDC68.

Shaft alternator: Marelli MJRM 710, 3300 kW / 4125 kVA.

SCR system: Wartsila

Auxiliaries: 2 x Caterpillar C32, 940 kWe @ 1800 rpm.

Harbour set: 1 x Caterpillar C18, 500 kWe @ 1800 rpm

 

Rudder Kongsberg high lift flap rudder.

Steering gear: Kongsberg Tenfjord SR 723 – 412 kNm.

Thrustesr: 2 x Brunvoll, 1400 kW / 1904 HP.

astrid engine room

Starting air compr.: 2 x Sperre HL5/105A.

Working air compr. 2 x Atlas Copco MAS GF11FF

Fuel oil cleaning: Green Oil filter.

Lub oil cleaning: Green Oil filter.

FO transfer pumps: 2 x Bombas Azcue.

Remote sounding: API / Marine Control Services.

Pumps:

  • Main engine cooling: Bombas Azcue.
  • Deckwash, fire and bilge pumps: Bombas Azcue.
  • Deck sump pumps: ITT Flygt

Main coolers: Kelvion, box coolers.

Bilge ejectors: Ellehammer.

FW pressure sets: 2 x Bombas Azcue.

Hot water tank: OSO, 200 l/ 2x15kW.

Sewage pumps: 2 x Bombas Azcue.

Sewage vacuum syst: Jets.

ASTRID

DECK EQUIPMENT

ASTRID FOREDECK

Electric winches: – all supplied by Kongsberg Brattvaag main system, electric:

2 x Trawl winches 97,0 t

1 x Tail-end winch 90,0 t

1 x Topline winch 90,0 t

2 x Netdrums 140,0 t

2 x Netdrums 100,0 t

2 x Purse seine winches 40,0 t

1 x End-wire winch 20,7 t

2 x Purse auxiliary winches 15,1 t

2 x Mooring winches 12,0 t

1 x Anchor windlass

2 x Netsounder winch

 

Fish pumping: – all supplied by MacGregor Rapp, electric:

3 x Cable reels.

3 x Fish hose reel.

3x MacGregor Rapp, electric fish pumps, 20”.

astrid PURSE SEINE WINCH

Purse handling: – all supplied by MacGregor Triplex,:

1 x Nethauler, Triplex 1020, electric 32,0 t

1 x Net crane, KNR-120, 7,0 tonnes x 13,8 m.

1 x Net crane, KNR-75

 

Deck cranes: – all supplied by MacGregor Triplex, hydraulic:

1 x Fore deck crane, KN-75, 4 tonnes x 18,0 m.

 

HP hydraulics: Complete drive system for cranes:

2 x 128 kW pump-units.

 

Trawl blocks Brdr. Markussen, Blue Line

Anchors & chains AC-14, supplied through Max Fodgaard.

ASTRID

FISH TANKS & PUMPING EQUIPMENT

ASTRID LOADING DECK
RSW-system:

3 x PTG FrioNordica, each 1300 kW / 1.118.000 kCal/h.

Circulation pumps 3 x 960 cum/h, Bombas Azcue

Condenser pumps 3 x 260 cum/h, Bombas Azcue

RSW circulation system with remote operated RSW-valves through Marine Control Services control system.

Actuators for valves: Eltorque.

RSW CONTROL ROOM
Vacuum-system: Önnereds Svets:

6 x 87 kW compressor units.

3 x 4000 l tanks.

ASTRID ACCOMMODATION &

LIFESAVING EQUIPMENT

MESS ROOM ASTRID

ACCOMMODATION

Wheelhouse: Shipyard.

Wheelhouse consoles: Shipyard / Norisol.

Accommodation: Maritime Montering, Norway.

Interior architect: Anitha Brix

Furniture: Maritime Montering / Ekornes, Norway.

Wheelhouse chairs: Nor-Sap 1600.

Ventilation plant: LF Ventilation.

Windows: Promap.

Window wipers: Wynn.

Galley equipment: Beha, Norway.

Paint supplier: PPG Sigma – vessel completely sandblasted and hot-zinc sprayed.

karstensens purser/trawler ASTRID

LIFESAVING – FIRE-FIGHTING:

MOB-boat: Viking Norsafe Mako-655 waterjet.

MOB-boat davit: Viking MDM DAF-375E.

Life rafts: 2 x Viking, 20 pers.

Watermist system: Survitec.

Fire detection: Scana Servoteknikk.

CHRISTIAN Í GRÓTINUM main engine
CHRISTIAN Í GRÓTINUM main engine

The Fishing Daily would like to congratulate the Johansson family on their new fishing vessel and wish everyone good and safe fishing well into the future

Karstensens Shipyard delivers new purser/trawler ASTRID to Skagen

by editor time to read: 16 min
0